Click To Call(689) 356-0104Click To Get A Free Estimate
Red brick paver entry walk curving past a flower bed toward a front door with a wreath

Warm brick color that lasts through the wet season

Brick Paver Sealing in Altamonte Springs, FL

Call (689) 356-0104 for a free brick paver sealing estimate at your Altamonte Springs home.

  • Brings out deeper paver color
  • Fresh joint sand helps lock pavers in place
  • Gives weeds less room to grow
  • Makes the surface easier to keep clean
  • Free estimate, no obligation

Request a Free Estimate

Free, no obligation.

Step 1 of 2

Where are your pavers?

Please choose one.

Free EstimateNo obligation
Fast ReplyWithin 1 business day, usually much sooner
Typical Local Price$1.50 to $3.00 a sq ft to clean, sand and seal
Call Now(689) 356-0104
Brick pavers

Can I book brick paver sealing for any street in Altamonte Springs?

Brick paver sealing in Altamonte Springs, FL can be booked for any street in town, and a local contractor replies inside 1 business day, usually much sooner. The estimate costs nothing and leaves the decision with you. To start, call (689) 356-0104.

Brick is a clay product, and it takes up water and dirt differently than gray concrete pavers do. A faded red walk that has gone pale and chalky can darken and look even again after a wash, fresh joint sand and a coat made for it. Say what the brick is, where it sits and how old the coat is when you ask for a free quote.

Call (689) 356-0104

Brick paver front walk with a freshly rolled glossy coat reflecting a porch light at dusk
Material

What makes brick pavers different from concrete ones?

A Central Florida sealing company notes that brick, travertine, concrete pavers and natural stone differ in porosity and sealing needs. Porosity decides how much sealer a surface drinks and how quickly water leaves it. That is why a contractor should ask what you have before naming a product. For a look at yours, call (689) 356-0104.

Is brick priced the same as other pavers?

An Orlando paver company lists a standard clean, sand and seal on brick pavers at $1.50 to $3.00 per square foot, and natural stone such as travertine at $2.00 to $3.50. The brick line matches the range on this site. When a bid for brick sits well above it, ask what was added. To compare, ask for a free quote.

Why does the type of sealer matter on brick?

A Central Florida company calls water-based sealer the Florida standard because it lets moisture escape and avoids white hazing, and it says solvent-based sealer can turn white and peel. Brick that stays damp after summer storms is the case where that choice counts. Ask the contractor to name the product before the work starts, or call (689) 356-0104.

Finish

Wet look or natural: which finish suits brick?

Brick takes both finishes well, and the choice is about taste and footing. A wet look deepens the red and brown tones and adds shine, while a natural or penetrating finish keeps the look the brick had when it was laid. Walks and steps that get wet deserve a question about grip. To see both on a spare brick, ask for a free quote.

Natural look

Keeps the faded-to-fresh look of clay with little shine. Often the pick for walks beside planting beds.

Wet look

Deepens color and gives the surface a sheen. Ask how it feels underfoot when damp before choosing it for steps.

Spare brick sample

A loose brick or a hidden corner lets you compare both finishes in your own light.

Color that holds

Whatever the finish, a washed and re-sanded surface shows the true color first, so choose after the wash.

Timing

When is the right season to seal brick pavers in Central Florida?

Timing matters more here than in most places, because the wet season is long. A Central Florida coating company cites the National Weather Service dating the rainy season from about May 25 to October 10, with the dry season starting in late October. Atlantic hurricane season runs through November 30, so the same company says to read the forecast before trusting the calendar. To plan a date, call (689) 356-0104.

Does rain a day ago still matter?

That company says there is no universal rule that brick is ready 24 or 48 hours after rain. Humidity slows evaporation and keeps joints and shaded pavers damp longer, so sun, airflow, drainage and the product label all decide. A contractor checks the joints before deciding. Ask how the call is made when you ask for a free quote.

What about the dry months?

Late October through spring brings much less rain, and the same company calls Florida winters mild enough for outdoor paver work. Drier months do not guarantee a good day, so the forecast still decides. If you are choosing a season, call (689) 356-0104 and ask which open dates a contractor has.

What do Altamonte Springs afternoons do to brick walks and entries?

Wikipedia lists a humid subtropical climate here with hot, humid summers, and an Orlando paver company counts over 50 inches of rain a year. Brick set in shade near a front door stays wet for hours after a storm. Damp brick grows green film and sheds joint sand into the street. One Altamonte Springs company page names joint sand washout after heavy rain and weeds in weakened joints as common problems here. To have a contractor look at yours, ask for a free quote.

Housing in the city is a mix. Wikipedia counts 22,990 housing units, and Cranes Roost, Uptown Altamonte and older streets near the lakes sit within a few miles of each other. Brick laid in different decades may carry different coats, or none. Tell the contractor what you know about your paving, and call (689) 356-0104 if you are not sure.

How it works

What is the brick paver sealing process?

Brick follows the same order as other paver work, with a gentle hand on the wash. An Orlando paver company says a standard job includes pressure cleaning, joint re-sanding and water-based sealer, and finishes in one day. To ask how a contractor handles old brick, call (689) 356-0104.

1. Look over the brick

The contractor checks the pavers, the joints, any old coat and where water stands.

2. Clean gently

Algae treatment and a low-pressure wash keep the clay face and the joints intact.

3. Refill the joints

Sand is swept in and wet down, then topped off once the brick dries.

4. Let the brick dry

Humidity slows drying, so the contractor checks joints and shaded spots before the roller starts.

5. Apply a sealer made for brick

The coat goes on dry brick with a sprayer and roller, in the finish you chose.

6. Walk the area with you

You see the finished walk, and the contractor says when feet, chairs and cars can return.

What if the brick already has a failed coat?

An Orlando company says failed sealer, whether cloudy, white or peeling, needs commercial removal, then re-sanding and resealing, at $3.50 to $5.00 per square foot over two to three days. Show the contractor the worst patch when you ask for a free quote.

Pricing

What does brick paver sealing cost in Altamonte Springs?

No page gave a separate rate for brick sealing alone, so this table is built from published pieces: washing alone at $0.15 to $0.75 per square foot, clean, sand and seal on brick pavers at $1.50 to $3.00 and strip and reseal at $3.50 to $5.00. A $1,000 project minimum appears on one company page, so small brick walks can price near it. For a figure written for your brick, ask for a free quote.

Size and condition move the total. A bigger area often costs less per foot, and algae, weeds and an old coat add prep time. Stripping failed sealer usually adds $500 to $1,000 or more on a Central Florida company page. Holding a bid already? Call (689) 356-0104 and compare it with the table.

Brick areaWashing alone at $0.15 to $0.75Clean, sand and seal at $1.50 to $3.00Strip and reseal at $3.50 to $5.00
300 sq ft$45 to $225$450 to $900$1,050 to $1,500
500 sq ft$75 to $375$750 to $1,500$1,750 to $2,500
800 sq ft$120 to $600$1,200 to $2,400$2,800 to $4,000
1,200 sq ft$180 to $900$1,800 to $3,600$4,200 to $6,000

Each column multiplies a published per square foot range from Orlando-area company pages read in November 2026. Your contractor sets the actual price after seeing the brick, and repairs and leveling are usually extra.

Get a Free Estimate

Stiff broom pushing pale sand into the seams of a brick paver patio after rinsing
Lifespan

How long does a coat last on brick pavers?

Two to four years, according to an Orlando paver company, with full-sun areas near two and shaded, lightly used ones near four. It suggests a maintenance cleaning every 12 to 15 months, which can stretch a coat. A Central Florida company says a bargain product may give out within 6 to 12 months of UV. Write down the product and the date, and call (689) 356-0104 when the water stops beading.

How do I know the coat is finished?

Water that soaks into the brick instead of beading is the clearest sign. Pale, chalky color and low joints follow. Mention the date of the last coat when you ask for a free quote.

Photos

How do sealed brick pavers look around Altamonte Springs?

Wide freshly sealed herringbone paver driveway at a split-level home under a live oak on an Altamonte Springs brick walkway
Family on lounge chairs by a sealed gray paver pool deck with a spa on an Altamonte Springs brick walkway
Sealed paver patio with wicker chairs beside a screened porch and a lake view on an Altamonte Springs brick walkway
Sealed paver walkway curving through azalea beds to a brick front entry on an Altamonte Springs brick walkway
Close view of new concrete pavers after sealing on an Altamonte Springs brick walkway
Paver driveway with one cleaned half beside a stained half on an Altamonte Springs brick walkway
Contractor rinsing a paver driveway with a pressure washer on an Altamonte Springs brick walkway
Two contractors spraying and rolling sealer on a driveway on an Altamonte Springs brick walkway

Which towns near Altamonte Springs can ask about brick sealing?

Every town below can request a free brick paver estimate. Pick yours to read its local notes, or call (689) 356-0104 if the street is not listed.

Questions

Frequently Asked Questions

How much to clean and seal pavers?

The Orlando-area range is $1.50 to $3.00 per square foot for a standard clean, sand and seal on brick pavers, and one Orlando company lists that exact line for brick. A 500 square foot walkway and entry runs about $750 to $1,500. Washing alone is listed at $0.15 to $0.75, and stripping at $3.50 to $5.00.

How long does paver sealing last in Florida?

Two to four years, according to an Orlando paver company, with full-sun areas near the short end and shaded, lightly used areas near the long end. A cleaning every 12 to 15 months is suggested to help the coat last. A bargain sealer may give out within 6 to 12 months.

Is it necessary to seal pavers in Florida?

Brick pavers have no rule that says they must be sealed. A Central Florida company notes that brick, travertine, concrete and natural stone differ in porosity, which is why the product choice matters when you do seal. A coat helps against fading and stains and needs repeating.

Is it worth it to seal pavers?

When color has faded or joints keep losing sand, the coat usually pays off. The price is a repeat visit every few years. Ask what each coat should do for your brick before you book, and compare the quote with the published range.

Is there a downside to sealing pavers?

Yes. The coat wears out, so the cost repeats. A coat laid over damp pavers can cloud, and the wrong product can turn white and peel, as a Central Florida company says solvent-based sealer can in Florida humidity.

Can brick pavers be sealed during the rainy season in Altamonte Springs?

Sometimes. A Central Florida coating company says there is no universal rule that brick is ready 24 or 48 hours after rain, because humidity, shade, airflow and joint dampness decide it. The National Weather Service dates the rainy season from about May 25 to October 10.

What sealer finish suits old brick pavers?

That depends on the look you want and how much grip the area needs. A water-based product is the Florida standard, according to a Central Florida company. Ask for a spare brick or a hidden corner so you can see matte and wet look side by side.

Does an old coat on brick pavers have to come off?

If it has turned cloudy, white or peeling, yes. An Orlando company says failed sealer needs commercial removal, then re-sanding and resealing, at $3.50 to $5.00 per square foot over two to three days.

Let the brick show its real color again

Describe the brick and where it sits, and a local contractor answers within 1 business day, usually much sooner.

Call (689) 356-0104

Free, no obligation